Plywood : Clip Definition Development

Below i have both the clip GH definition as well as the resulting rhino view-port with the definition on and running. The equilateral triangles shown are just samples that are being used as place-makers for the purpose of developing this definition. To start the definition takes perimeter curves from each panel and divides in thirds. From those points lines are developed. Through dispatch and expression editor, the only curves allowed to stay on are under 1″. Using these 1″ lines as the markers for the clip geometry, a orient by plane definition is used to orient the clip geometry (developed in earlier posts) to each clip point. Next the clips need to be labeled (by panel) and oriented to a base plane for fabrication.

Team “Ramrod”  Plywood

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s